Oil system cleaners Liqui Moly 1990

Oil-Schlamm-Spulung enhanced engine flush is used to clean engines when they are very much contaminated and there is sludge formed in the system after long-term over-heating, out-of-specification oil change, water flow in the system, use of poor-quality oils and fuel. A high contamination level can be identified by greasy deposits under the oil cover. It helps eliminate system failures caused by contamination such as noises of chain drive, knocks of hydraulic lash adjusters. It is recommended for cars with the mileage more than 100 000 km. It is filled 150 - 200 km prior to the oil change. It does not require special preparation. A flush bottle of 300 ml is used for 5 L of oil. Properties. It dissolves the strongest sludge and lacquer deposits. Thanks to the special set of additives and long-term effect, it penetrates deep in the most hard-to-reach places and cleans all internal hydraulic actuators of the engine: hydraulic lash adjusters, hydraulic tensioners, VVT-i, V-TEC, VANOS, etc. It extends the oil service life. Thanks to the package of protective additives, motor oil safely cleans the engine and forms a protective film reducing friction. It comprises a set of substances for rubber parts of the system. It is fully drained from the system together with oil oil. The flush is universal for diesel and gasoline engines. The product allows you to independently clean the engine which has the heaviest contamination in the most hard-to-reach places and units of the lubrication system. Application. Add it in the old oil of the warmed-up engine 150-200 km prior to the planned change time in the proportion of 300 ml for 5 L of motor oil. Use the car as usual and don’t exceed 2/3 of the engine power. When 150-200 km are achieved, drain the old oil, replace the oil filter and fill in the fresh high-quality oil.